3.2.14. Device Reset Locally Command Class, version 1

The Device Reset Locally Command Class is used to notify central controllers that a Z-Wave device is resetting its network specific parameters.

\requirement{CC:005A.01.00.12.001}{0}

Any node SHOULD support this Command Class if it can be reset to factory default.

3.2.14.1. Device Reset Locally Notification Command

The Device Reset Locally Notification Command is used to advertise that the device will be reset to default.

\requirement{CC:005A.01.01.11.001}{0}

The reset operation MUST reset protocol data (HomeID, NodeID, etc.). For Z-Wave Plus nodes, additional requirements upon node reset are provided in Section 8.

\requirement{CC:005A.01.01.11.002}{0}

In case a Lifeline destination is configured in Association Group #1, the device MUST send a Device Reset Locally Notification Command to the Lifeline destinations.

\requirement{CC:005A.01.01.11.004}{0}

The Device Reset Locally Notification Command MUST be issued by the Root Device. If Multi Channel encapsulation is used, the source End Point MUST be set to 0.

Table 3.47 Device Reset Locally Notification Command

7

6

5

4

3

2

1

0

Command Class = COMMAND_CLASS_DEVICE_RESET_LOCALLY (0x5A)

Command = DEVICE_RESET_LOCALLY_NOTIFICATION (0x01)